I am in a clients office and the system has dropped the roll feed setting for the fourth time. I understand there is a way ro add the feeder setting through user tools. Can anyone help!!!
Thanx
Original Post
Problem SC508 code (cutter error) Ricoh bullentin #B125-008
The cutter has malfunction, even though all I did was replace the waste toner container.
You can turn the roll feeder back on by following these steps after the SC508 error has occured.
[LIST]
User Tools
System Settings
Key Op Tools
Next key
Select "Do Not Use By-Pass"
Select "OK"
Exit Out
Turn On & Off
Hope this helps, there is suppose to be a software fix in the near future.
The cutter has malfunction, even though all I did was replace the waste toner container.
You can turn the roll feeder back on by following these steps after the SC508 error has occured.
[LIST]
Hope this helps, there is suppose to be a software fix in the near future.