2035e sp making spots

Darth Vader (Guest)

We have a new 2035e sp making spots. It usually happens after it sits unused for a few hours. After a few copies, it clears up. We've increased the fusing temperature (twice). This seems to provide a temporary fix, but after a few days, it starts back.

It happens on print AND on copy.

We have replaced the fusing unit, drum unit, developer, put a PM kit in, made laser adjustments, toned down the boldness.

Any suggestions?

8/17/0510:20 AM

❤️ 0

Original Post

Replies sorted oldest to newest

beachcopy (Guest)

Sounds like a tough one. Maybe bad toner?? I haven't had this problem, but maybe try new toner with dev change, seems like you've done everything else. Just a shot.

8/17/052:34 PM

❤️ 0

Darth Vader (Guest)

Thanks, but we've already put a new bottle in, and it still does the same thing.

8/18/0510:31 AM

❤️ 0

Jomama (Guest)

This was addressed in TB B135-004. It describes several CQ problems associated with the faster warm-up feature. Chief among them is the temperture of course but in order to overcome some of the problems you have to effectively detone the machine. It is important to follow the directions exactly and apply the correct solution.
I have experianced all of the symptoms listed and have overcome all of them in 1 or often 2 visits. OK maybe three visits.
Good luck.

8/19/059:33 AM

❤️ 0

Darth Vader (Guest)

It took several trips, but we did manage to solve the problem.

Thanks for the help.

10/26/059:06 AM

❤️ 0